Designer: Fernando Dasilva
Bordeaux shoulder dusters
Technique: Wire wrapping – looping/double links

 Material list :
10 inches of 18mm brown Artistic Wire mesh – A144-H-118
4 gold-color ‘c’ crimp ends with out chain extension – 324A-020
5 gold-color ornate bead caps – 329A-012
2 gold-plated plain lever backs – 308A-014
2 copper star ball head pins- 312P-110
2 gold-color 2’ eye pins – 310A-013
2 4mm gold-color jump rings – 314A-003
Source: Beadalon

2 14mm crystal red magma round large hole beads – article 5900
2 10mm crystal pearl Bordeaux – article 5810 001 538
Source: SWAROVSKI ELEMENTS collection

Tools:
Flush Cutters  202E-001
Chain nose pliers  201E-002
Round-nose pliers  201E-003
Flat nose pliers  201E-007
Source: Beadaon

Instructions:

1. Cut Artistic Wire Mesh in half.

2. Fold one piece of the mesh to fit square flat section of ‘c’ crimp end. Use flat nose pliers width to narrow the mesh and make the folds.

3. Insert folded section of mesh into the ‘c’ crimp end and then use flat-nose pliers to close it tight around the mesh. Repeat the same with the opposite end of mesh.

4. Feed one bead cap, one crystal red magma bead followed by another bead cap onto copper head pin. Make a wrapped loop on top of bead. Trim excess wire.

5. Feed one bead cap followed by a crystal pearl onto the pin. Make a simple loop on top of pearl and then trim excess wire.

6. Open loop next to bead cap of the pearl link and then attach to crystal dangle. Close it back carefully. 

7. Open loop next to pearl bead and then attach to one of the pieces of mesh through loops of ‘c’ crimp. Close it gently.

8. Open 4mm jump ring , attach to the other ‘c’ crimp loop of brown mesh section and then to plain lever back. Close it gently.

9. Repeat all steps to finish other side of earrings.