Materials Needed
Copper Beads – Blue Moon Beads #65026
Stone Carved Beads – Blue Moon Beads #59145
Leather Cord – Westrim Crafts #852-002
Instructions
1. To make the open loop knot used as a “button hole,” begin
with the 18 inch length of leather cord and fold over a 4 inch length
from one end. Then grasp both pieces at the end of the 4 inch length and
tie an overhand knot, leaving a 1 inch loop opening. Trim excess tail
from the loop.
2. String 7 Copper Beads.
3. To make the center focal point, tie an overhand knot 3 inches away
from the knotted loop. String 1 Carved Stone Bead and secure in place
with another knot, being careful to pull it snugly to the Carved Stone
Bead.
4. Slid 7 additional Copper Beads and tie another knot 3 inches from the
center focal point. String the second large Carved Stone Bead and secure
in place snugly with a very tight knot. Trim off excess tail to finish.