301-4

Photo Bracelet
By: Katie Hacker

Sponsored by:
Pure Allure “Crystal Innovations”


click to close this project window
click to print this project window

Materials Needed
4 silver photo sliders with light rose Swarovski® crystals
12 rose 6mm Swarovski® crystal bicone beads
18 light rose 4mm Swarovski® crystal bicone beads
Crystal Innovations silver heart toggle clasp with light rose crystals
Beadalon ®16” length of .018” diameter beading wire
2 silver crimp tubes
Index-size photo print
Beadalon® wire cutters
Beadalon® crimping tool
Scissors

Instructions
1. Remove the plastic insert from a photo slider.
2. Using the plastic as a template, cut out your chosen index-size photos.
3. Place a photo and plastic insert inside each slider.
4. Cut two pieces of beading wire.
5. Hold the beading wires together and string a crimp tube.
6. Loop the wires through half of the clasp and back into the crimp bead.
7. Crimp it.
8. Hold the wires together and string a 4mm bead and a 6mm bead.
9. Separate the strands and string a 4mm and a 6mm bead onto each.
10. Place each beading wire end through a hole on a photo slider.
11. String a 4mm bead, a 6mm bead and a 4mm bead onto each wire.
12. Repeat Steps 8-9 three times, then string another photo slider.
13. String a 6mm and a 4mm bead onto each strand, then hold the wires together and string a 6mm bead and a 4mm bead.
14. Use a crimp tube to attach half of the clasp to the end of the bracelet.
15. Cut off any extra beading wire.

Project Images  



.

click to close this project window
click to print this project window