|
|
|
|
1 pair of purchased sweater clips
Assorted beads – 2mm to 10mm
Optional: 1 focal bead
Beadalon® 12” – 14” length of flexible beading wire
Beadalonü wire cutters or scissors
Beadalon® needle nose pliers
1. Center the focal bed on the beading wire. Add beads on each side to
measure a total of 8” – 8 ½” or desired length.
2. Thread the beading wire through the hole on the sweater clip. Tie securely
in a knot. Thread the excess wire back through 3 to 5 beads. Trim off
the excess wire. Repeat for the other end pulling the wire firmly to tighten
the beads.
NOTE – If using a crimping bead, thread the crimp bead on to the
wire through the clip and back through the crimp. Crimp the bead tightly
and continue as directed in the previous step.
|
|
|