405-1

Crystal Floral Bracelet
By Debba Haupert

Sponsored by:
Pure Allure “Crystal Innovations”

 
click to close this project window
click to print this project window

Finished size 7 ¼” long.

Materials Needed
3 “Crystal Innovations” light amethyst crystal/floral resin sliders
2 “Crystal Innovations” silver floral sliders with tanzanite Swarovski® crystals
“Crystal Innovations” silver floral toggle clasp with tanzanite Swarovski® crystals
10 tanzanite 6mm Swarovski® crystal bicone beads
34 light amethyst 4mm Swarovski® crystal bicone beads
16” length of .015” diameter Beadalon® 49 beading wire
2 silver crimp beads
Beadalon® wire cutters
Beadalon® crimping tool

Instructions
1. Cut the beading wire in half. Hold the wires together and string a crimp bead and half of the clasp. String the beading wires back through the crimp bead. Use a crimping tool to crimp it.

2. Hold the wires together and string a 4mm and a 6mm bicone bead.

3. Separate the wires and string two 4mm beads onto each wire.

4. String one beading wire through the upper holes on the floral resin slider and the other wire through the lower holes.

5. String two 4mm, one 6mm and one 4mm bead onto each beading wire.

6. String one beading wire through the upper holes of the silver floral slider and the other wire through the lower holes.

7. String one 4mm, one 6mm and two 4mm beads onto each wire.

8. String one beading wire through the upper holes on the second floral resin slider and the other wire through the lower holes.

9. Repeat steps 5, 6,7 and 8.

10.End by stringing two 4mm bicone beads on each wire. Bring the wires together and string one 6mm and one 4mm bicone bead.

11. Hold the wires together and string a crimp bead and half of the clasp. String the wires back through the crimp bead. Crimp it, then cut off any extra wire.

 

Project Images  

 

click to close this project window
click to print this project window