|
|
|
|
Lime Silk Jewelry Strand
Aqua Silk Jewelry Strand
Natural Silk Jewelry Strand
Spiral Bead Cones
Large Wide Curb Silver Chain
Large Glass Drop Pendant – Blue/Light Blue Stripes
Glass Matte Ocean Mix Glass Beads
6mm Silver Balls
Silver Diamond Toggle Clasp
From Westrim Crafts®
Big Eye Crafting Needle
Medium Crimps
2 1” eye pins
1. Begin by cutting 3-22” lengths of silk strands, 1 length from
each of the 3 colors. Holding the ends of the 3 Silk Strands together
by one end, secure those ends together with the Medium Crimp. Cut a 28”
length of Large Wide Curb Silver Chain and thread the Green Silk Strand
through the first link. Slide the chain up the Green Silk Strand as close
to the Medium Crimp as possible and secure into place by tying the Silk
Strand in a knot around the link.
2. Thread the Green Silk Strand onto the Big Eye Needle and weave through
the entire length of chain. Remove the needle and knot the end around
the last link, leaving about a half inch of Green Silk Strand exposed.
3. Thread the Natural Silk Strand onto the Big Eye Needle and begin stringing
with a combination of glass and silver beads. The beads will require persuasion
to fit onto the silk cord and will float approximately 1” apart
onto the strand. String the Natural silk Strand with 4 Matte Glass Beads
(of desired colors) interchanged with a Silver Ball in between After the
fourth Matte Glass Bead, add another Silver Ball followed by the Large
Glass Drop Pendant and remove the Crafting Needle.
4. Thread the Aqua Silk Strand onto the Big Eye Crafting Needle and string
the beads alternating as in Step 3, but beginning with the silver Ball
and ending with the Matte Glass Bead. Thread the Aqua Silk Strand also
through the Large Glass Drop Pendant and then finish string the length
in the opposite pattern. Remove the Big Eye Crafting Needle
5. Thread the Green Silk Strand onto the Big Eye Crafting Needle and string
the remaining half in the opposite pattern used in the first half.
6. Taking the three ends of the Silk Strands together, secure the Silver
Crimp as in Step 1. To disguise the crimp with the Spiral Bead Cone, attach
an Eye Pin, with the open end toward the pendant. Pull the Eye Pin through
and create a plain loop close to the Spiral Bead Cone, trim off any excess
wire from the Eye Pin.
7. Setting this end aside, add the Spiral Bead Cone (as done in Step 6)
to the opposite side, where the necklace was started. To finish the necklace,
add the clasp to each end by opening the plain loop, adding the toggle
and securing shut. The finished necklace length is approximately 22”
|
|
|
|
|